Description
Nano (Arduino Nano Compatible Atmega328p+CH340) is based on famous Arduino platform and does all the functions of Uno, but with a smaller footprint.This development board provides small plate with the same powerful microcontroller. It is compatible with Arduino and ideal for fast prototyping and easy integration. It’s vital for your small project where you don’t need much of a pin-outs but the small size is very important to make it look good. The board equips a low-cost USB-Serial Chip that makes it less in price than Nano with FTDI USB-Serial Chip used on older versions of Arduino Nano.The Nano is a small, complete, and breadboard-friendly board based on the ATmega328 . It lacks only a DC power jack and works with a Micro USB cable instead of a standard one.
The board can be powered via the Micro-USB connection, 6-12V unregulated external power supply (pin 30), or 5V regulated external power supply (pin 27). The power source is automatically selected to the highest voltage source.The size of board is only 43 mm x 18 mm, it comes with 6 PWM I/O from the total of 14 digitals I/O, 8 analog inputs, 16Mhz clock speed and 32kB of flash memory. It can be programmed directly from the Arduino IDE, using the Micro USB connection.
Note: This board is a 100% compatible clone version with same design as Arduino Nano. It is not the original version which is made in Italy. CH340 chip might not work directly with some PC/Laptop, you will need some ch340 drivers.
Specifications:
- Microcontroller: Atmega328P
- Voltage: 5V
- Input Voltage: 7V – 12V
- I / O pins: 14
- PWM pin 6 (out of 14 I / O)
- ADC pin: 8 (out of 14 I / O)
- Flash Memory: 32KB (2KB used by bootloader)
- SRAM:2 KB
- EEPROM:1 KB
- Current I / O pin: 40mA / pin
- Communication: TWI, SPI and UART
- Operating frequency: 16MHz
- Dimensions: 45mm x 18mm
- Micro USB
Features :
- 1 pair of TTL level serial transceiver ports RX / TX
- Using Atmel Atmega328P-AU MCU
- There is a bootloader installed in it
- Support USB download and Power
- Support for external 5V ~ 12V DC power supply
- Support power supply by 9V battery
- Support ISP download
- Automatic reset during program download
- Power OK blue LED on the bottom
- Green (TX), red (RX) and orange (L) LED
- +5V to AREF jumper
- Auto sensing/switching power input
- Small Micro USB for programming and serial monitor
- ICSP header for direct program download
- Standard 0.1” spacing DIP (breadboard friendly)
- Manual reset switch
